Our plans for Satellite Station 4.0 are based, in part, on the idea that we can extend our current remote operating environment to include Satellite Operations. Now that our ISS Crew Contact is complete, the antennas from the current Satellite Station 3.0 can be permanently installed at our QTH.
The first step in the project is to put up a second, 35′ house bracketed tower. Our new tower will also feature a new 6m yagi along with a permanent installation of our Satellite 3.0 Antennas. The first step in the project was to secure a building permit and prepare the footing for our new tower. Using Rohn’s specifications for the 45G Tower that we are using calls for the first section of the tower to be placed 4′ below ground in a concrete form. It’s important to place a foot or so of stone at the base of the footing and to ensure that the legs of the tower remain open so water can drain. Failure to do this part of the preparation properly will result in water freezing in the Tower Legs which will split them open and ruin the tower.
Also, note the rebar reinforcing material in the hole around the tower and the bracing to keep the first section of the tower level and plumb. The folks at Form King did an excellent job in preparing and pouring the footing for our new tower.
The picture above shows the completed tower base. We’ve also installed a lightning ground on each of the three legs of the tower and the ground are bonded to each other and to the rest of our station’s ground system.
With a few sections of the tower in place, it was time to install the house bracket. The bracket needs to be reinforced with blocking material on both sides of the wall. The blocking and the bracket are held together with 10″ galvanized bolts.
We chose a 2″ x 25′ Chrome Molly Mast for our tower. We wanted to have about 10′ of mast above the top of the tower. Rather than cut the mast, we choose to keep the mast full length by setting our M2 Orion Rotator down a section and a half from the top of the tower. This is a good thing to do for several reasons. First, it makes the rotator easier to access for service. Also, the mast can twist a bit to absorb the torque on the rotator when the antennas start and stop moving.
The combination of the 25′ tower and the 10′ of mast above top will place our Satellite Antennas at a height of about 45′. This will provide additional clearance above the trees in our backyard for low angle satellite contacts.
The next step in our project will be to rebuild and reinforce the Satellite 3.0 Antenna Cross Boom and rotator system, build our new 6m yagi, and install the antennas on our new tower. You can read about other parts of our project via the links below.
- Portable Satellite Station Part 7 – Plans for a 4.0 Station
- Satellite Station 4.0 Part 2 – Antennas
- Satellite Station 4.0 Part 3 – Antenna Integration and Testing
- Satellite Station 4.0 Part 4 – Tower Camera and J Mode Desensitization Filter
- Satellite Station 4.0 Part 5 – New IC-9700 Transceiver
- Satellite Station 4.0 Part 6 – Tower Finishing Touches
- Satellite Station 4.0 Part 7 – Flex SDR Satellite Transceiver
- Satellite Station 4.0 Part 8 – GPSDO Frequency Locking
- Satellite Station 4.0 Part 9 – Upgraded Simple Portable Station
- Satellite Station 4.0 Part 10 – Adding 23 cm To Our Satellite SDR
- Satellite Station 4.0 Part 11 – Phone Patch/Telebridge Capability